Civil · MEP · Structural 2102 Business Center Drive, Suite 130, Irvine, CA 92612 Mon to Fri, 8am to 6pm (949) 482-7835
ENERGY COMPLIANCE

REScheck and COMcheck reports.

Energy code compliance reports for residential and commercial projects in states that use the national energy codes, prepared for the permit application.

Not ready to send plans?

Start with a free project review.

Leave your name and email. We reach out, look at what you have and tell you which engineering the project needs.

A project review is a scoping conversation. It is not engineering advice, and no design work begins until a proposal is signed.

Energy compliance for projects outside California.

Most states outside California check energy code compliance with two reports from the U.S. Department of Energy software: REScheck for homes and small residential buildings, and COMcheck for commercial buildings. The building department asks for the report with the permit application.

We prepare these reports for the out-of-state projects we engineer. Our MEP engineering is available in all 50 states, so the report and the mechanical, electrical and plumbing drawings can come from one team. California projects use Title 24 instead, which we also prepare.

Our office is in Irvine. MEP engineering is available throughout California and in all 50 states. Our team travels to the site when the project needs it.

What we deliver
  • REScheck compliance report for residential projects
  • COMcheck envelope, mechanical and lighting reports
  • Inputs matched to the drawings
  • Report formatted for the plan set
  • Revisions when the design changes during plan check
Scope

What the reports cover.

REScheck

  • New homes
  • Additions and alterations
  • Insulation and window values
  • Mechanical equipment efficiency

COMcheck

  • Building envelope
  • Interior and exterior lighting
  • Mechanical systems
  • Water heating

What we need from you

  • Floor plans, elevations and sections
  • Window and door schedule
  • Wall, roof and floor assemblies
  • The energy code edition your jurisdiction has adopted, if known
Project types

Projects we prepare the reports for.

Homes and additions

REScheck for single-family and small residential projects.

Commercial buildings

COMcheck for new buildings and alterations.

Tenant improvements

COMcheck lighting and mechanical reports for commercial suites.

Get started

What to send for a proposal.

We review the scope and reply with a written fee proposal and schedule.

Request a proposal
  • Project address and building type
  • Square footage and number of stories
  • Scope: mechanical, electrical, plumbing or all three
  • Architectural plans in PDF, if available
  • Target submittal date
Common questions

REScheck and COMcheck reports FAQ.

What is the difference between REScheck and COMcheck?

REScheck is used for single-family homes and low-rise residential buildings. COMcheck is used for commercial buildings and high-rise residential buildings.

Are REScheck and COMcheck accepted in California?

No. California uses its own Energy Code, Title 24 Part 6, with its own forms and approved software. We prepare Title 24 forms for California projects.

Which energy code edition do you use?

The edition adopted by the state or the local jurisdiction where the project is located. We confirm it before starting.

Can you prepare the report without doing the MEP design?

Yes. We can prepare the report from your drawings and the equipment selected by others.

Ready to send the plans?

Share the drawings and the project address. Fee and schedule are quoted per project after review.